Making a Spin Casting Mould/Mold with Siloset Low Temp Casting Rubber
1
2
3
4 
5
6
1 Place one half of rubber mold and remove center.
2 Push masters into bottom half of mould can.
3 Dust with release agent (talc or French chalk).
4 Place mushroom in bottom half of mould. Replace top half of mould in the mold can and then can lid.
5 The prepared mould should then be placed in a rubber press @ 90-105 deg/centigrade for about 40 minutes.
6 Remove can from press and open to reveal cured mould. Remove cured mould from can.
It is preferable to allow a cooling time before splitting mould and removing masters.
